Emmi-Nail Rubber Base Crystal Clear 15ml

Emmi-Nail Rubber Base Crystal Clear 15ml - base gel and build-up gel

The medium-viscosity, clear Emmi-Nail Rubber Base Gel is used for priming during modeling with Shellac or UV/LED gel. At the same time, you can use it as a build-up gel for both applications. The flexible, rubbery consistency adapts perfectly to the nail and gives thin and brittle nails additional strength. Even with problem nails, the result is super adhesion. Seal the rubber gels with our Emmi-Nail UV/LED-Lacquer Base-/ Top Coat.

With the Shellac/ UV/LED polish manicure, you can strengthen your nails with the Rubber Base and still protect them with the Emmi-Nail Remover. For gel modeling, conjure up a quick build-up or refill.

✔ Improved formula
✔ Priming gel and build-up gel in one product
✔ UV- and UV/LED-curing
✔ medium viscosity
✔ Hema-free
✔ vegan
✔ Content: 15ml

The Emmi-Nail Rubber Base Gel is suitable as:

• Gel for strengthening natural nails
• Base and build-up gel for a more stable UV polish manicure

Application:

1. Prepare the natural nail and apply a Buffer.
2. Apply our Emmi-Nail Prep&Prime and allow to air dry briefly.
3. Apply Emmi-Nail Rubber Base like nail polish and cure (120 sec. under UV/LED or 120 sec. UV light)
4. For lengthening or strengthening, apply the rubber base again and cure again.
5. Do not apply the gel too thickly, rather work in 2 or more layers and let it harden in between.
6. Now apply a Emmi-Nail UV-Lack Quickie and let it harden.
7. The Emmi-Nail UV lacquer Base-/ Top Coat is used as a sealant. (no sealant is required for the quickies, as these varnishes cure without an inhibition layer)
.
8. After curing with the High-Gloss Cleaner to remove the inhibition layer.

Removal:

• Roughen the paint with the Refine Buffer File 100/180 until it no longer shines. CAUTION: Please only roughen the varnish, not the natural nägel.
• Drop a Remover Wrap with the Remover. Wrap the nail with the wrap and leave the remover on for 8 minutes. For a better hold, clip the wrap with our Remover Clips. For better removal, hold your nails in your curing device during the application time.
• Finish the nail with a polishing file or continue with the nail modeling.

Or

• Pour some remover into a manicure bowl and dip your nails in. Leave the remover to work for approx. 3 minutes, then carefully try to remove the layer of polish with a Rosenholzstäbchen. If the layer does not come off, leave the remover to work for another minute.